Jump to content
Sign in to follow this  
  • entries
    663
  • comment
    1
  • views
    14,052

Model Airplane Tips & Tricks

Sign in to follow this  
JShumate

26 views

From aluminum foil to household corner molding, these cheap and easy workshop tips use common items or scr*p material to make your RC airplane modeling time easier and more enjoyable. Have a great tip you’d like to share? Email it to man@airage.com!

OVERSPRAY PROTECTOR
MAN_139_11_1111_003_img002.jpg
When you’re painting, it’s important to protect parts from overspray. This could include pushrods, landing gears, motor mounts, etc. You can use masking tape, but that can be difficult to remove. An easier m*thod is to tightly wrap all the parts that need protection with aluminum foil-it’s far easier to remove than tape. If you still need that sharp tape line, just mask off where the part meets the painting surface.

HOME FOR YOUR BOLTS
MAN_139_11_1111_003_img003.jpg
Here is an easy way to make sure you have your Allen bolt for attaching your canopy to your fuselage when you get to the field. Just make this handy bracket to hold your bolts inside the aircraft. The bracket is cut from plastic corner molding or aluminum angle iron. Cut a piece about 2-3 inches long and drill four holes into it for the bolts to hang in place. Epoxy or scr*w the bracket somewhere out of the way inside the fuselage. Now when you pull you bolts out of the canopy, just slide them into the brackets and they’ll be there the next time you are ready to assemble the plane.

GIVE YOUR FOAM A GLOSS LOOK
MAN_139_11_1111_003_img004.jpg
If you paint foam with acrylic paint it gives it a nice look and makes it a little more durable. Acrylic paint is great to use because it will not react with the foam, and it will leave a flat dull finish, which is great for warplanes or military aircraft, but not so good for aerobatic and civilian aircraft. You can put a shine on the finish by using liquid acrylic long-lasting Shine floor wax. It will dry in about 20ñ30 minutes leaving your color scheme with a good-looking and shiny paint job.

TOUGHING UP YOUR WHEEL PANTS
MAN_139_11_1111_003_img005.jpg
Running wheel pants on any surface will wear them down and dirt and grass runways are especially rough on them. Here’s an easy way to reinforce them. First, cut out a small square shim out of 1/64 plywood sheet. Place this shim inside the wheel pant, over the attachment point, where the Allen scr*ws bolt into the blind nuts. Glue them in place with CA or epoxy. Now thin out a small batch of epoxy with rubbing alcohol and coat the entire inside of the wheel pants. This will help to strengthen it while still keeping the weight down. This should give them a fighting chance on rough fields and the not-so-perfect takeoff and landings.

The post Model Airplane Tips & Tricks appeared first on Model Airplane News.


View the full article

Sign in to follow this  


0 Comments


Recommended Comments

There are no comments to display.

×
×
  • Create New...